![]() ![]() This will expose the Torx-head bolts that hold the rails in place. The instructions are as follows:- Find the plastic trim panel underneath each cross brace on the Honda Ridgeline's roof rack and pull it off with your hands to release the clips that secure the panel. When the Cross Bars are removed and properly reinstalled, the noise goes away. To remove the roof rack from Honda Ridgeline. It's not a difficult job, but there are some tricky parts. The top surface of each Cover should be flush with the surface of each Side Rail.įield complaints of a wind noise, described as a low level “howl” starting at approximately 25 m.p.h., have been traced to improper installation of the Cross Bars. I give a step by step look at how to install an OEM roof rack on my 2008 Honda Ridgeline. When reinstalling the Support Covers, make sure they are fully seated by giving each a light blow with a closed fist. Make certain the Screws holding the Rear Supports to the Rails are snug and the bottom surfaces of the Rails and Supports are flush with one another. Use 3M Ultra Pro body sealer on the ends of the eight (T30) Support Bolts and make sure the white rubber sealing sleeves are in place.
0 Comments
Leave a Reply. |